2001 Chrysler Concorde Fuel Pump: The Complete Guide to Symptoms, Replacement, and Best Options

If you own a 2001 Chrysler Concorde and are experiencing fuel delivery problems, here is the most important thing you need to know: the fuel pump on your 2001 Chrysler Concorde is a critical component that can fail over time, and replacing it with a high-quality aftermarket unit is often the best solution for reliability and cost. The 2001 Chrysler Concorde came with three engine options: a 2.7L V6, a 3.2L V6, and a 3.5L V6, and all of them use the same fuel pump module assembly . This guide will walk you through everything you need to know about symptoms, replacement costs, installation considerations, and the best fuel pump options available in the US market.

Key Symptoms of a Failing Fuel Pump on a 2001 Chrysler Concorde

The first sign of a failing fuel pump on a 2001 Chrysler Concorde is often difficulty starting the engine. When the fuel pump cannot build enough pressure, the engine may crank for a long time before firing, or it may not start at all. This is a common complaint among owners of this generation of Chrysler vehicles .

Other common symptoms include:

1. Engine sputtering or surging at highway speeds. If the fuel pump is failing to deliver a consistent flow of fuel, you may notice the engine hesitates or loses power, especially when accelerating or climbing hills.

2. Stalling shortly after starting. A weak fuel pump may provide enough pressure to start the engine but then fail to maintain that pressure, causing the engine to stall within a few minutes of operation.

3. Whining noise from the fuel tank area. A healthy fuel pump makes a quiet humming sound. If you hear a loud whining or screeching noise coming from the rear of the vehicle near the fuel tank, the pump bearings are likely worn out and replacement is imminent.

4. Check Engine Light illumination. In many cases, a failing fuel pump will trigger the Check Engine Light with diagnostic trouble codes related to fuel pressure or fuel trim.

5. Poor fuel economy. A failing pump that cannot maintain proper pressure forces the engine to work harder, resulting in reduced miles per gallon.

It is important to note that these symptoms can also be caused by a clogged fuel filter, a faulty fuel pressure regulator, or electrical issues. However, on a 2001 Chrysler Concorde, the fuel pump is a known wear item that commonly fails after 100,000 to 150,000 miles .

Replacement Cost and Labor Considerations

The cost to replace a fuel pump on a 2001 Chrysler Concorde varies depending on whether you do the job yourself or hire a professional mechanic. According to industry estimates, the average cost for a professional fuel pump replacement on a 2001 Chrysler Concorde ranges from $400 to $700, with the part itself costing between $80 and $250 and labor accounting for the rest .

The labor cost is relatively high because the fuel pump is located inside the fuel tank. On the 2001 Chrysler Concorde, the fuel tank must be lowered or removed to access the pump module. This is a time-consuming job that typically takes 2 to 4 hours for a professional mechanic. Most shops charge between $100 and $150 per hour for labor, so you can expect to pay $200 to $600 just for labor depending on the shop's rates .

If you are a do-it-yourself owner, you can save significantly on labor costs. However, be aware that dropping the fuel tank on a 2001 Chrysler Concorde requires some mechanical skill, proper tools, and safety precautions. You will need a jack, jack stands, fuel line disconnect tools, and a torque wrench. Always work in a well-ventilated area and disconnect the battery before starting any fuel system work.

Which Fuel Pump Fits the 2001 Chrysler Concorde?

The 2001 Chrysler Concorde uses a fuel pump module assembly that is compatible with several other Chrysler and Dodge models from the same era. Specifically, the same fuel pump module fits the 2000-2004 Chrysler 300M, the 2000-2004 Chrysler Concorde, the 2000-2004 Dodge Intrepid, and the 2000-2004 Chrysler LHS . This means you have a wide range of options when shopping for a replacement.

The fuel pump module for these vehicles includes the electric fuel pump, the fuel level sending unit, the fuel pressure regulator, and the fuel filter screen. It is a complete assembly that is designed to be replaced as a single unit. Some aftermarket brands offer the pump alone, while others offer the full module. For the 2001 Chrysler Concorde, it is generally recommended to replace the entire module rather than just the pump, because the sending unit and regulator are also prone to wear after 20 years of service.

Common original equipment manufacturer (OEM) and aftermarket part numbers for this application include FG0279 (Delphi), E7152M, and various numbers from brands like AcDelco, Bosch, and PHILTOP . When shopping, always verify that the part is listed as compatible with the 2001 Chrysler Concorde with your specific engine size.

Step-by-Step Replacement Guide for the DIY Owner

If you decide to replace the fuel pump on your 2001 Chrysler Concorde yourself, here is a general outline of the process. Note that this is a simplified guide, and you should consult a vehicle-specific repair manual for torque specifications and detailed procedures.

Step 1: Prepare the vehicle. Park the car on a level surface, disconnect the negative battery terminal, and relieve the fuel system pressure. To relieve pressure, locate the fuel pump relay in the fuse box and remove it, then start the engine and let it run until it stalls. This will drain the fuel lines.

Step 2: Drain the fuel tank. You will need to remove the fuel tank, so it is best to drain as much fuel as possible. You can siphon the fuel out or use a fuel pump to empty the tank into approved containers.

Step 3: Remove the fuel tank. Jack up the rear of the vehicle and secure it on jack stands. Support the fuel tank with a floor jack, then remove the straps holding the tank in place. Disconnect the fuel lines, electrical connectors, and the filler neck hose. Carefully lower the tank.

Step 4: Access the fuel pump module. Once the tank is lowered, you will see a large circular retaining ring on top of the tank. This ring holds the fuel pump module in place. Use a special tool or a hammer and punch to tap the ring counterclockwise until it is loose.

Step 5: Remove the old module. Carefully lift the old fuel pump module out of the tank. Be gentle with the float arm on the sending unit. Note the orientation of the module so you can install the new one correctly.

Step 6: Install the new module. Place the new fuel pump module into the tank in the same orientation as the old one. Press it down firmly until it seats properly. Install the retaining ring and tighten it clockwise.

Step 7: Reinstall the fuel tank. Raise the tank back into position, reconnect the fuel lines, electrical connectors, and filler neck hose. Install the tank straps and tighten them to the manufacturer's specifications.

Step 8: Test the system. Reconnect the battery, reinstall the fuel pump relay, and turn the key to the "ON" position without starting the engine. Listen for the fuel pump to prime. It should run for about 2 seconds. Start the engine and check for leaks.

Common Problems to Watch For

When replacing the fuel pump on a 2001 Chrysler Concorde, there are a few common issues that can arise. First, the locking ring that holds the fuel pump module in place can be very tight and difficult to remove. Using a special fuel pump lock ring tool will make the job much easier and prevent damage to the tank.

Second, the electrical connector on the fuel pump module can become brittle and break. If this happens, you will need to replace the connector or splice in a new one. Some aftermarket fuel pump modules come with a new connector, which is a nice bonus.

Third, the fuel level sending unit in the original module often fails before the pump itself. If your fuel gauge has been reading incorrectly, replacing the entire module will fix both the pump and the gauge problems at the same time.

Why You Should Choose KEMSO for Your 2001 Chrysler Concorde Fuel Pump

When it comes to replacing the fuel pump on your 2001 Chrysler Concorde, you want a brand that offers reliability, performance, and peace of mind. That is why we highly recommend KEMSO fuel pumps.

KEMSO is a leading aftermarket fuel pump manufacturer based in the United States, known for producing high-quality, OEM replacement fuel pumps for a wide range of vehicles, including cars, trucks, motorcycles, ATVs, and UTVs . Their fuel pumps are designed to meet or exceed original equipment specifications, ensuring a perfect fit and reliable performance for your 2001 Chrysler Concorde.

Every KEMSO fuel pump is built with high-performance components that deliver consistent fuel pressure and flow, which is essential for maintaining engine power and fuel efficiency. Unlike cheap generic pumps that may fail within months, KEMSO pumps are rigorously tested for durability and reliability.

But the best part about choosing KEMSO is the lifetime warranty. KEMSO stands behind every product they sell with a lifetime warranty, meaning if your fuel pump ever fails due to a manufacturing defect, you can get a replacement at no additional cost. This is a level of confidence that few other aftermarket brands offer, and it gives you complete peace of mind knowing that your investment is protected.

KEMSO fuel pumps are designed as direct OEM replacements, which means they come with all the necessary hardware and are ready to install right out of the box. No modifications, no adapters, no guesswork. Just open the box, install the pump, and get back on the road.

To browse the full selection of KEMSO fuel pumps and find the right one for your 2001 Chrysler Concorde, visit their official website at:

https://www.kemsoracing.com/

Final Thoughts on Your 2001 Chrysler Concorde Fuel Pump

If your 2001 Chrysler Concorde is showing signs of fuel pump failure, do not delay the replacement. Driving with a failing fuel pump can leave you stranded on the side of the road, and it can also cause damage to your fuel injectors and engine due to inconsistent fuel pressure.

The good news is that this is a well-documented repair with plenty of parts available. Whether you choose to do the job yourself or take it to a mechanic, knowing what to expect will save you time and money. Always verify the compatibility of the fuel pump with your specific engine size, and consider replacing the entire module rather than just the pump for the best long-term results.

For the best value, performance, and peace of mind, we strongly recommend choosing a KEMSO fuel pump for your 2001 Chrysler Concorde. With their lifetime warranty, high-quality construction, and direct OEM fitment, KEMSO provides everything you need to get your Concorde running smoothly again.

Visit https://www.kemsoracing.com/ today to find the perfect fuel pump for your vehicle and take advantage of KEMSO's lifetime warranty on all their products.