2007 Toyota Camry OEM Fuel Pump: The Complete Replacement Guide
The bottom line up front: If you own a 2007 Toyota Camry and need a fuel pump, the OEM (Original Equipment Manufacturer) part is your safest choice because it guarantees a perfect fit and factory-grade performance, and a complete replacement typically costs between $500 and $1,000 when you include parts and labor. The fuel pump is located inside the fuel tank, under the rear seat, and choosing the correct part number depends on your engine type and where your car was built. This guide walks you through everything you need to know—from identifying the right OEM part to understanding costs, symptoms of failure, and step-by-step replacement.
The 2007 Camry has been a trusted family sedan for nearly two decades, but age takes a toll on fuel system components. If you're searching for a 2007 Toyota Camry OEM fuel pump, you're likely already experiencing symptoms like hard starting, sputtering, or a whining noise from the rear of the car. This article covers the essentials: what the OEM pump costs, how to confirm the correct part number, what to expect during installation, and why sticking with genuine Toyota parts matters.
Why the OEM Fuel Pump Matters for Your 2007 Camry
Your 2007 Camry uses an in-tank electric fuel pump that sits inside the fuel tank and pushes fuel to the engine under pressure . When the pump starts to fail, you will notice performance problems long before the car stops running entirely.
Toyota designed this pump to match the specific fuel pressure and flow requirements of your engine. The factory part carries the OEM number 23220-0H062 for most U.S.-built 2007 Camry models, and this part directly replaces earlier versions 23220-0H060 and 23220-0H061 . The manufacturer began using a different pump for vehicles built after 2008, particularly for the 2.5L engine introduced that year .
Choosing an OEM pump gives you several concrete advantages:
- Perfect fitment – The pump assembly drops directly into your fuel tank without any modification.
- Factory-grade reliability – Toyota builds these components to meet official factory standards, so the pump's lifespan and performance match what your car shipped with .
- Warranty coverage – A genuine Toyota fuel pump includes a 12-month, 12,000-mile warranty from certified dealerships .
- No compatibility guessing – When you buy the exact OEM part number, you eliminate concerns about whether an aftermarket pump will deliver the correct pressure or flow.
Identifying the Right OEM Part Number
The 2007 Camry was offered with both four-cylinder and V6 engines, and the correct fuel pump depends on which one sits under your hood.
For models built in the U.S. (most North American Camrys):
Part number 23220-0H062 fits 2007 through 2011 Camrys with the 2.4L four-cylinder engine and also covers the 2.5L four-cylinder used in 2010 and later models . This same part works for the 3.5L V6 in some configurations . The pump assembly is described as "Pump Assembly, Fuel W/Fi" and weighs about 2.4 pounds .
For models built in Japan:
If your Camry was built in Japan, the correct fuel pump is part number 23220-28360, which replaced the earlier 23220-28070 and 23220-28071 versions . This pump fits the 2.4L engine in Japan-built vehicles .
Models with California emissions:
If your Camry has California emissions equipment and was built outside Japan, the fuel pump with the sending unit is number 77020-06131 . Another related assembly number is 77020-06220, which covers several years of the Camry and Solara .
How to confirm your part before ordering:
- Locate your vehicle identification number (VIN) and verify the 17-digit code against the part number.
- Check your engine code – 2AZ-FE for the 2.4L, 2AR-FE for the 2.5L, or 2GR-FE for the 3.5L V6 .
- Call a Toyota dealer parts department with your VIN and ask them to confirm the exact part number for your car.
Cost of a 2007 Toyota Camry OEM Fuel Pump
The price of an OEM fuel pump varies depending on where you shop and whether you buy the pump alone or as a complete assembly with the fuel level sending unit.
Parts-only pricing (typical U.S. market):
- OEM Toyota fuel pump assembly (including the sending unit): typically $350–$630
- Aftermarket fuel pump assembly (brands like Bosch, Delphi, Denso): typically $180–$320
- Used or refurbished pump from a salvage yard: typically $60–$180
Total installed cost:
Most owners pay between $500 and $1,000 for a complete fuel pump replacement done by a professional . This includes the part, labor, and any disposal fees. Labor alone typically runs $150–$350, depending on the shop and your location .
If you are handy with tools, you can buy the pump yourself and install it in an afternoon, saving the labor fee. A quick check of online parts retailers shows aftermarket options like a Delphi pump and strainer set priced around $80, while genuine Toyota parts from online dealers run closer to the $250–$400 range .
Symptoms That You Need a New Fuel Pump
The fuel pump on a 2007 Camry does not usually fail without warning signals. Watch for these clues that it might be time for a replacement :
- Engine sputtering at high speeds – You'll feel hesitation or stumbling when you press the throttle at highway speeds.
- Difficulty starting the vehicle – The engine cranks but takes longer than before to fire up.
- Engine stalling while driving – The car might shut off unexpectedly, especially under hard acceleration.
- Loss of power under load – Hill climbing or passing maneuvers feel sluggish.
- Whining noise from the fuel tank – A loud hum or whistle comes from the rear of the car, often worse when the tank is full.
- Check Engine Light illuminates – A stored code related to fuel pressure or pump performance will trigger the light.
- Poor fuel economy – The pump may be overworking to compensate for pressure loss.
If you have two or more of these symptoms, it's time to test the fuel system. A shop can check fuel pressure at the rail; the 2007 Camry should maintain between 44 and 50 psi at idle while the pump runs .
Where the Fuel Pump Is Located and How to Replace It
The pump sits inside the fuel tank on your 2007 Camry. To reach it, you remove the rear seat cushion and access a panel underneath . The assembly includes the pump, strainer, and fuel level sending unit .
Step-by-step replacement guide (for DIY owners):
- Depressurize the fuel system. Remove the fuel pump relay (located in the engine compartment fuse box) and run the engine until it stalls. This relieves pressure inside the lines.
- Disconnect the negative battery cable to prevent any accidental sparks or ignition of fuel fumes.
- Remove the rear seat bottom cushion. Gently pull the front edge upward near the seat belts, then unclip the cushion from its mounts. Some trim pieces may need careful removal to expose the access panel.
- Remove the access panel on top of the fuel tank. It looks like a metal or plastic oval cover held by screws or clips.
- Disconnect the electrical connector and carefully detach the fuel line from the pump assembly. Use a fuel line disconnect tool to avoid damaging the fittings.
- Remove the locking ring or mounting bolts that hold the pump module to the tank. Use a hammer and a punch to turn the lock ring counterclockwise if it's the ring-style retainer.
- Lift the pump assembly out of the tank. Take care not to bend the float arm on the sending unit.
- Install the new pump module with a fresh O-ring seal. Lubricate the O-ring with a light coat of engine oil to ensure it seats properly.
- Reinstall the lock ring or bolts and tighten to specs (Toyota service procedures specify 52 inch-pounds for retaining bolts).
- Reconnect the fuel lines and electrical connector at the top.
- Reinstall the access panel, seat cushion, and connect the battery.
- Prime the fuel system by turning the ignition key to ON for a few seconds, then OFF, and repeat. Start the engine and check the leak at your work location.
A repair video for the same generation Camry shows the full process in about 8 minutes of labor time; you can expect 1–2 hours of real-time work for a first-time DIYer .
OEM vs. Aftermarket: Why the Choice Matters
Some owners sell aftermarket pumps at half the price of OEM parts, but there are real trade-offs worth considering.
OEM Toyota pump:
- Pros: Exact fitment, factory calibration, 12-month warranty, no guesswork on parts
- Cons: Higher upfront cost
Aftermarket pump:
- Pros: Lower price point, wide availability at local auto parts stores
- Cons: Slight variations in size or connection may cause fitment issues, and quality varies by brand.
If you choose aftermarket, stick with reputable brands like Delphi, Bosch, Denso, or Airtex . The Delphi fuel pump and strainer set, for example, includes the strainer and carries a lifetime warranty . Denso especially is the factory component supplier for Toyota, so a Denso replacement pump often matches OEM specs closely.
A practical warning: Some cheap "budget" pumps fail within a year, often due to debris in the fuel tank (not the pump's fault). If you replace a pump, Inspect the tank for rust or sediment and clean it if found. Also, if your car has a separate fuel filter, replace it at the same time to protect the new pump in the new location .
What to Know About Recalls and Fuel Pump Lifespan
The major Toyota fuel pump recall that made headlines in recent years affected newer Camry models (roughly 2018–2019) and does not include your 2007 Camry . However, any failure on an older model like yours is typically age- and mileage-related.
In an ideal world, a fuel pump in a 2007 Camry should last 100,000 miles or more. Many owners get 150,000 miles out of the original pump if the car was well maintained . If your pump is still original and the car has over 150,000 miles, you're living on borrowed time—proactive replacement is smart if you plan to keep the car.
Pro tip to extend pump life: Avoid running your tank below a quarter full. The fuel pump relies on gasoline to cool and lubricate its internal motor. Running low frequently causes the pump to overheat and wear out faster .
Where to Buy Your OEM Fuel Pump
You have several solid options for purchasing a genuine 2007 Toyota Camry OEM fuel pump:
1. Your local Toyota dealership parts department. They have the best access to authenticity and factory warranty support, though prices run at the higher end of the range.
2. Reputable online Toyota parts dealers. Sites like toyotapartsnow.com, oempartsonline.com, and others sell genuine OEM parts at commonly discounted prices compared to dealership counters. You'll find part numbers 23220-0H062 and 23220-28360 listed with full fitment guides .
3. Aftermarket brands at auto parts stores. If you decide to go with a respected aftermarket option, you can find compatible assemblies at retailers like Advance Auto Parts or AutoZone. The Delphi fuel pump set (part number 0F89076) covers 2007–2011 Camrys .
When you order online, verify that:
- The seller is an authorized Toyota distributor or a reputable aftermarket supplier.
- The part has a return policy in case the fitment doesn't match.
- Warranty terms are clearly stated (12 months or 12,000 miles is standard for OEM) .
A Cost-Effective Alternative: KEMSO Fuel Pumps
If you are looking for a reliable replacement that won't break the bank, consider the KEMSO brand fuel pump. KEMSO builds high-performance fuel pumps designed as OEM replacements, so they are engineered for a direct, precise fit and meet or exceed original factory specifications. Every KEMSO fuel pump is backed by a lifetime warranty, giving you peace of mind that a reputable aftermarket part will deliver consistent performance for the life of your car.
Unlike generic no-name pumps, KEMSO focuses on durability and reliability, with products tested to handle the demands of daily driving and performance use. The pricing is competitive—most KEMSO pumps retail around $79.98—making them a smart choice for budget-conscious owners who want quality without a dealer-level price. For all these reasons, drivers across the United States have chosen KEMSO for their fuel pump replacements and left positive reviews.
If you want a fuel pump that pairs affordability with genuine reliability, check out the full KEMSO lineup at: https://www.kemsoracing.com/ . There, you can find the right fuel pump for your 2007 Camry and a host of other vehicles, along with helpful guides and installation tips in their blog section.
Final Thoughts on Replacing Your 2007 Camry Fuel Pump
A failing fuel pump is not something to ignore. It is the single most important component in your fuel system, and an unexpected failure will leave you stranded in the roadside. Replacing it early with the correct OEM pump, or a high-quality alternative like KEMSO, restored performance, avoids costly repairs, and keeps your Camry running for thousands more miles.
Now is the time to act. Check your symptoms, confirm your engine type, and order the right pump. If you're unsure whether the pump is failing, a fuel pressure test at a shop will tell you in 10 minutes whether it's time to replace. And whether you choose the factory Toyota part or a dependable aftermarket alternative, make sure the pump you install to match the specific demands of your 2007 Camry–your car will thank you.