2015 Dodge Dart Fuel Pump: Symptoms, Replacement, and the Best Upgrade for Your Vehicle

If you own a 2015 Dodge Dart and are experiencing starting issues, loss of power, or strange noises from the rear of the car, the fuel pump is likely the culprit. The fuel pump in your 2015 Dodge Dart is a critical component that delivers fuel from the tank to the engine. When it starts to fail, the entire vehicle becomes unreliable. The best course of action is to replace a failing fuel pump immediately with a high-quality, OEM replacement unit. Ignoring the warning signs can lead to engine damage, catalytic converter failure, and being stranded on the road. For the 2015 Dodge Dart, the replacement process is straightforward, and investing in a premium pump with a lifetime warranty is the smartest financial decision you can make. We recommend the KEMSO brand Fuel Pump as the best solution for your vehicle.

Common Symptoms of a Failing Fuel Pump in a 2015 Dodge Dart

Recognizing the early warning signs of a failing fuel pump can save you time, money, and a major headache. Here are the most common symptoms specific to the 2015 Dodge Dart:

  1. Hard Starting or Extended Cranking: One of the first signs of a weak fuel pump is when the engine cranks longer than usual before starting. The pump is not building enough pressure to prime the fuel system quickly.

  2. Whining Noise from the Fuel Tank: A healthy fuel pump operates quietly. If you hear a loud, high-pitched whining sound coming from the rear of the car (near the fuel tank), it indicates the pump is working harder than it should, often due to wear or debris.

  3. Loss of Power Under Load or Uphill: If your Dart struggles to accelerate, especially when going uphill or carrying a heavy load, the fuel pump may not be delivering enough fuel volume to meet the engine's demand. This can cause the engine to sputter or hesitate.

  4. Engine Stalling, Especially When Hot: A failing fuel pump can cause the engine to stall unexpectedly, particularly after the car has been running for a while and the pump has gotten hot. The internal motor may fail when heat builds up.

  5. Check Engine Light On: The check engine light can illuminate with codes related to fuel system pressure (P0087, P0088, P0191, etc.). A failing pump often triggers these codes.

  6. Surging or Rough Idle: If the fuel pump delivers inconsistent pressure, the engine may surge or run rough at idle, feeling like it is about to stall.

  7. Complete No-Start Condition: In the worst case, the pump fails completely, and the engine will not start at all. You may hear the starter cranking, but the engine will not fire.

How to Diagnose a Fuel Pump Problem in Your 2015 Dodge Dart

Before replacing the pump, you should confirm the diagnosis. Here is a simple DIY method:

  • Listen for the Prime: Turn the ignition key to the "ON" position (do not start the engine). You should hear a faint humming sound from the rear of the car for one to two seconds. This is the fuel pump priming. If you hear nothing, the pump may be dead.
  • Check the Fuse and Relay: Locate the fuel pump fuse and relay in the fuse box (usually under the hood or in the cabin). Swap the relay with a similar one (like the horn relay) to see if the pump comes back to life.
  • Fuel Pressure Test: The most reliable method is to perform a fuel pressure test. A mechanic can connect a pressure gauge to the fuel rail. The 2015 Dodge Dart typically requires between 5-60 psi depending on the engine. If the pressure is low or drops quickly, the pump is failing.

Step-by-Step Guide to Replacing the Fuel Pump on a 2015 Dodge Dart

Replacing the fuel pump on a 2015 Dodge Dart is a moderate DIY job. The pump is located inside the fuel tank, and you can access it through an access panel under the rear seat.

Tools You Will Need:

  • New fuel pump assembly (KEMSO recommended)
  • 13mm socket and ratchet
  • 10mm wrench
  • Trim tool set
  • Flat blade screwdriver
  • Safety glasses and gloves
  • Drain pan
  • Rags

Step 1: Relieve Fuel System Pressure
Remove the fuel pump fuse from the fuse box. Start the engine and let it run until it stalls. This depressurizes the fuel lines. Then, disconnect the negative battery terminal.

Step 2: Access the Fuel Pump
Open the rear seat (the bottom cushion lifts up). Locate the access panel on the floor under the seat. Remove the screws or bolts holding the panel in place. You will see the top of the fuel pump module.

Step 3: Disconnect the Old Pump
Carefully disconnect the electrical connector and the fuel lines. Use a fuel line disconnect tool if necessary. Be prepared for some fuel to spill. Use a clean rag to catch any drips.

Step 4: Remove the Old Pump Assembly
Use a lock ring tool or a hammer and brass punch to turn the retaining ring counterclockwise. Lift the entire pump assembly straight out of the tank. Note the orientation of the float arm and the position of the strainer.

Step 5: Install the New KEMSO Fuel Pump
Transfer any necessary brackets, hoses, or connectors from the old pump to the new KEMSO pump. Ensure the new O-ring seal is properly seated in the tank opening. Insert the new pump assembly into the tank, aligning it correctly. Install the retaining ring and tighten it securely.

Step 6: Reconnect Everything
Reconnect the fuel lines and electrical connector. Make sure the connections are tight and secure. Reinstall the access panel and the rear seat.

Step 7: Test the System
Reconnect the battery. Turn the ignition to the "ON" position without starting the engine. Listen for the fuel pump to prime for one to two seconds. Check for fuel leaks at all connections. Start the engine and let it run for a few minutes. Check for leaks again. Take the car for a test drive to ensure smooth operation.

Why You Should Choose KEMSO Fuel Pump for Your 2015 Dodge Dart

When it is time to replace your fuel pump, do not buy the cheapest replacement you can find. Cheap aftermarket pumps often fail within months, leaving you with the same problem and the same labor costs. You need a pump that matches or exceeds the original equipment manufacturer (OEM) specifications. That is why we recommend KEMSO Fuel Pumps.

KEMSO specializes in manufacturing high-performance, OEM replacement fuel pumps designed for a wide range of vehicles, including the 2015 Dodge Dart. Their products are built with premium materials and precision components to ensure reliable performance under all driving conditions.

Key Features of KEMSO Fuel Pumps:

  • High Performance: KEMSO pumps deliver consistent fuel pressure and flow, suitable for both stock daily drivers and modified engines.
  • OEM Replacement: Designed as direct bolt-on replacements, KEMSO pumps fit seamlessly into your vehicle's existing fuel system without any modifications.
  • Lifetime Warranty: Every KEMSO fuel pump comes with a lifetime warranty. This means you only buy it once. If it ever fails due to a manufacturing defect, KEMSO replaces it at no cost. This is the gold standard in the fuel pump industry.
  • American Market Focus: KEMSO is based in Houston, Texas, and their products are designed with the needs of American drivers in mind, handling extreme heat and cold without compromise.

For 2015 Dodge Dart owners, the KEMSO fuel pump is the best investment you can make. It eliminates the worry of a sudden breakdown and saves you money on future replacements. You can browse their full selection of fuel pumps and check the fitment for your specific car at their website.

👉 Visit KEMSO Racing today: https://www.kemsoracing.com/ to find the perfect fuel pump for your 2015 Dodge Dart and get the peace of mind that comes with a lifetime warranty.

Maintenance Tips to Extend the Life of Your Fuel Pump

Once you have installed a new fuel pump, proper maintenance will help it last for years. Follow these simple habits:

  1. Keep Your Tank at Least a Quarter Full: The fuel in the tank cools and lubricates the pump. Running the tank low frequently causes the pump to overheat and wear faster. This is the number one cause of premature pump failure.
  2. Replace the Fuel Filter on Schedule: A clogged fuel filter forces the pump to work harder, reducing its lifespan. Replace the filter every 30,000 to 60,000 miles as recommended by your owner's manual.
  3. Use Quality Fuel from Reputable Stations: Poor-quality fuel contains contaminants that can clog the pump strainer and damage internal components. Stick with major brands.
  4. Address Check Engine Lights Promptly: If you see lean codes or fuel pressure codes, have the system diagnosed early before the pump fails completely.
  5. Listen for Changes: If the pump becomes louder or starts making unusual noises, inspect it immediately. Early detection can prevent a complete failure.

Final Thoughts

A failing fuel pump in your 2015 Dodge Dart is not something to ignore. The symptoms are clear: hard starting, loss of power, stalling, and whining noises. Replacing the pump early with a high-quality unit like the KEMSO fuel pump is the best way to restore your vehicle's reliability. The installation process is straightforward and can be done at home with basic tools.

Do not wait until you are stranded on the side of the road. Check your fuel system today and upgrade to a KEMSO high-performance fuel pump for worry-free driving and maximum power.

For the best selection of high-performance, OEM replacement fuel pumps with a lifetime warranty, visit https://www.kemsoracing.com/ today. Their team can help you find the exact pump for your 2015 Dodge Dart and get you back on the road with confidence.


Back to blog