Fuel Pump for 2013 Ford Fusion: Complete Replacement Guide, Symptoms, and Best Options

The bottom line: If you own a 2013 Ford Fusion and are experiencing hard starting, engine sputtering, loss of power during acceleration, or a whining noise from the rear of the car, the fuel pump is likely failing. Replacing it promptly is critical to avoid being stranded. For a reliable, long-lasting solution, we recommend the KEMSO fuel pump—a high-performance, OEM replacement unit backed by a lifetime warranty. You can find it at KEMSO Racing.

Understanding Your 2013 Ford Fusion Fuel Pump

The fuel pump in your 2013 Ford Fusion is an electric pump located inside the fuel tank. Its job is to send fuel from the tank to the engine at the correct pressure, typically around 55-65 psi for this model. The pump works with a fuel pressure regulator and a fuel filter (often integrated into the pump module). When this pump fails, your engine doesn't get enough fuel, leading to performance issues or a no-start condition.

Common Symptoms of a Bad Fuel Pump in a 2013 Ford Fusion

Recognizing the signs early can save you from a breakdown. Here are the most common symptoms:

  1. Engine Cranks but Won't Start: This is the most obvious sign. You hear the starter turning the engine over, but it never catches. If you don't hear a faint whirring sound from the rear of the car when you turn the key to the "on" position (before cranking), the pump is likely dead.

  2. Sputtering or Surging at High Speeds: The car may run fine at low speeds but start to sputter, jerk, or lose power when you press the accelerator on the highway. This indicates the pump can't supply enough fuel under high demand.

  3. Loss of Power Under Load: When going uphill or carrying a heavy load, you feel a sudden drop in power. The engine may hesitate or stumble.

  4. Whining Noise from the Fuel Tank: A healthy fuel pump produces a quiet, constant hum. If you hear a loud, high-pitched whine or a grinding noise coming from the rear of the car (especially near the fuel tank), the pump is wearing out.

  5. Engine Hesitation or Stalling: The car may hesitate when you press the gas pedal, or it may stall at low speeds, like when coming to a stop at a traffic light.

  6. Check Engine Light Illuminates: The powertrain control module (PCM) may detect low fuel pressure or a lean fuel mixture (too much air, not enough fuel) and trigger the check engine light. Common trouble codes include P0087 (Fuel Rail/System Pressure Too Low) and P0191 (Fuel Rail Pressure Sensor Circuit Range/Performance).

Why the Fuel Pump Fails

Several factors contribute to fuel pump failure in the 2013 Ford Fusion:

  • Running on Low Fuel Frequently: The fuel pump relies on gasoline to cool and lubricate it. When you regularly run your tank below a quarter full, the pump can overheat and wear out faster.
  • Clogged Fuel Filter: If the fuel filter is dirty (often part of the pump module), it forces the pump to work harder, leading to premature failure.
  • Contaminated Fuel: Dirt, water, or debris in the fuel tank can damage the pump's internal components.
  • Old Age and Mileage: Fuel pumps typically last 100,000 to 150,000 miles. If your Fusion has over 100,000 miles, it's in the high-risk zone.

Replacement Cost for a 2013 Ford Fusion Fuel Pump

The total cost to replace a fuel pump on a 2013 Ford Fusion varies depending on whether you do it yourself or hire a mechanic.

  • DIY (Do It Yourself):

    • Part Cost: A quality aftermarket fuel pump module (the whole assembly with pump, filter, and sending unit) ranges from $120 to $250. A cheap no-name pump may be $60, but it's risky.
    • Labor: Zero if you do it yourself. You'll spend about 2-3 hours.
    • Special Tools: You may need a fuel line disconnect tool ($10-$20). A new fuel pump gasket or seal may also be needed ($5-$15).

  • Professional Mechanic:

    • Part Cost: The mechanic may charge retail price for the part, typically $180-$350.
    • Labor Cost: Most shops charge 1.5 to 2.5 hours of labor. At $100-$150 per hour, labor ranges from $150 to $375.
    • Total Cost: Expect to pay between $350 and $650 at a professional shop. Dealership prices are higher, often $600-$900.

Step-by-Step Replacement Guide (For DIYers)

Replacing the fuel pump on a 2013 Ford Fusion is a moderate-difficulty job. Always work with a fire extinguisher nearby and in a well-ventilated area. Here is a simplified guide:

Step 1: Safety First. Disconnect the negative battery terminal. Relieve fuel system pressure by removing the fuel pump fuse (found in the passenger compartment fuse box, usually fuse #27 or #54) and crank the engine until it stalls. Then turn the ignition off and replace the fuse.

Step 2: Access the Fuel Pump. The fuel pump is located inside the fuel tank. On the 2013 Ford Fusion, the access is through a panel under the rear seat. Fold the rear seat down. You'll see a metal access cover held by four bolts. Remove the bolts and lift the cover.

Step 3: Disconnect Electrical and Fuel Lines. You'll see the top of the fuel pump module. Disconnect the electrical connector (push the tab and pull). Use a fuel line disconnect tool to release the two fuel lines (one supply, one return). Have rags ready for any spilled fuel.

Step 4: Remove the Old Pump. Use a plastic or brass pry tool (not a metal screwdriver, which can spark) to gently pry the metal locking ring counterclockwise. Some models require a special socket. Lift the ring out, then carefully lift the pump module out of the tank. Note the orientation of the float arm.

Step 5: Install the New Pump. Compare the new pump module to the old one. Transfer the rubber gasket (or O-ring) from the old pump to the new one. Insert the new pump module into the tank in the same orientation. Press down firmly and install the locking ring, turning it clockwise until it locks.

Step 6: Reconnect Everything. Reattach the fuel lines (push them until they click). Reconnect the electrical connector. Reinstall the access cover and bolts. Put the rear seat back in place. Reconnect the battery.

Step 7: Test. Turn the key to the "on" position (without starting) for 3 seconds. You should hear the pump prime for 1-2 seconds. Do this 3-4 times to build pressure. Then start the car. Check for any fuel leaks around the access panel.

How to Choose the Best Fuel Pump for Your 2013 Ford Fusion

When shopping for a replacement, you have three main options: OEM (dealership), aftermarket budget, and high-performance aftermarket. Here is why you should avoid the cheapest option:

  • OEM (Ford): Guaranteed fit and performance but expensive (often $400+ for just the part). Usually comes with a 1-year warranty.
  • Budget Aftermarket: These sell for under $100. They often fail within 6-12 months, cause pressure issues, or don't fit perfectly. You get what you pay for.
  • High-Performance Aftermarket (like KEMSO): These are designed to meet or exceed OEM specifications. They use better materials, flow more fuel, and are built to last. They often come with comprehensive warranties.

Why You Should Choose the KEMSO Fuel Pump for Your 2013 Ford Fusion

If you want a fuel pump that you can install and forget about for years, the KEMSO brand is the clear winner. Here are the specific reasons:

  1. High Performance: KEMSO fuel pumps are engineered for high flow rates and consistent pressure. This means your Fusion’s engine gets exactly the fuel it needs, whether you're cruising on the highway or accelerating onto an interstate ramp. The pump runs smoothly and quietly.

  2. OEM Replacement Quality: KEMSO pumps are direct fit replacements. They come as a complete module assembly, including the pump, filter, sending unit, and float. You do not need to modify anything or buy extra parts. Just remove the old one and install the new one. The connectors and hose fittings match the factory design perfectly.

  3. Lifetime Warranty: This is the biggest benefit. KEMSO stands behind its products. Every fuel pump purchased from KEMSO comes with a lifetime warranty. If the pump ever fails due to a manufacturing defect (which is extremely rare with their build quality), you can get a replacement at no cost. No other brand offers this level of long-term protection. It completely eliminates the worry about future failures.

  4. Trusted by Enthusiasts and Professionals: KEMSO has a reputation in the automotive community for making reliable parts. They focus specifically on fuel system components, so they know the details. Their pumps are tested rigorously before being shipped.

Where to Buy the KEMSO Fuel Pump for Your 2013 Ford Fusion

Don't waste time searching multiple stores or worrying about counterfeits. The best place to purchase your KEMSO fuel pump is directly from their official online store: KEMSO Racing.

Visit their website at: https://www.kemsoracing.com/

On their site, you can browse their full range of fuel pumps for the 2013 Ford Fusion and many other vehicles. They provide clear product photos, specifications, and compatibility information. The checkout process is secure, and they ship from their warehouse in Houston, Texas. They also have a dedicated customer support team that can answer any questions before or after your purchase.

Final Thoughts

Dealing with a bad fuel pump is frustrating, but a proper replacement doesn't have to be a headache. By choosing a high-quality part like the KEMSO fuel pump, you are investing in reliability and peace of mind. The combination of OEM fitment, high performance, and a lifetime warranty is unmatched. For your 2013 Ford Fusion, this is the smartest purchase you can make.

Remember to check your symptoms carefully first, and if you decide to replace the pump yourself, follow the safety steps above. Once you have the KEMSO pump installed, your car will feel responsive and reliable again. Head on over to KEMSO Racing to get your replacement today.

Website: https://www.kemsoracing.com/


Back to blog